Replacement Guides RSS

nintendo switch screws -

There is screws pack included in ExtremeRate's Nintendo Switch replacement shells package. Here is an instruction for you to distinguish where the different screws be used during the installation.  Note: *You can re-use the original screws that from the original shells, our screws are for your back-up;  *We only provide those screws that you need with the items you purchased;  *The below images shows all screws for full shells of console and Joy-cons.  ------------------------------------------------------------------------------------------------------------ ------------------------------------------------------------------------------------------------------------

Read more

Our JDM-04 PS4 controller front shell is also compatible with JDM-04 version, what you need to just cut out some structures inside of the top shell.  Please see the instruction below: 

Read more

PS4 LED Light Installation instructions: 1.Please check if the batteries have electricity and the controller in good condition firstly.                       2.  Following the steps in the below pictures to take apart your ps4 controller and install the LED light panel.   Step  One (1) Disassemble your PS4 controller,replace to transparent ABXY buttons, Dpad and thumbsticks firstly. Step Two (2)  Tear off the sticker on the back of the LED light panel and stick to the position shown in the picture. Step three (3)  Make sure the buttons ,joysticks and LED light...

Read more

Introduction Use this guide to remove the plastic top cover.   Step 1 Top Cover Carefully peel the warranty sticker up off the lower case to reveal a hidden screw cover. Turn the PS3 over and lay it on its backside. Carefully peel the warranty sticker up off the lower case to reveal a hidden screw cover. To avoid activating the VOID that may come up, heat the sticker carefully to remove and replace it cleanly.   Step 2 Use the flat end of a metal spudger to pry up the seven screw covers around the edge of the lower...

Read more

  Introduction Use this guide to replace your PlayStation 3 Slim's CR 2032 coin-cell PRAM battery.   Step 1 Top Cover Carefully peel the warranty sticker up off the lower case to reveal a hidden screw cover. Turn the PS3 over and lay it on its backside. Carefully peel the warranty sticker up off the lower case to reveal a hidden screw cover. To avoid activating the VOID that may come up, heat the sticker carefully to remove and replace it cleanly.   Step 2 Use the flat end of a metal spudger to pry up the seven screw covers...

Read more